Some of the above images have been provided by Tropicalfishfinder. Please be aware that variations within species mean that the fish you are sent may not be identical to the fish in the photographs.

© 2003-2017 Tropical Fish Finder | All Rights Reserved | E&OE

TF2YD Stores > Real Aquatics > Reflectors> Arcadia Classica CS120F 47 Led Stretch Freshwater 120cms 42x LEDs Stretch


Arcadia Classica CS120F 47 Led Stretch Freshwater 120cms 42x LEDs Stretch

Category: Reflectors

Price: £83.49 each

Discount: No discounts available

Stock: 2 in stock



Further details:

Further information can be found below:

Volume Discount: No discounts available
Size: NA

Arcadia Classica CS120F 47 Led Stretch Freshwater 120cms 42x LEDs Stretch

Extendable Arm
The extendable arm allows the lamp to be mounted on a wide range of aquarium tanks.
The LEDs
The Freshwater unit utilises a mix of 1.5W at 10,000K, 8,000K, RGB and 0.24W RGB LED's.


Provides
the ripple effect.
Low energy
consumption.
Additional Clips
For extra stability.
Light unit
waterproof to IP67.

Additional Clips
For extra stability, each unit is supplied with clamp fixings (x4" tank widths 8-18mm).

Dual Switch Controller The dual light mode recreates daylight and moonlight conditions for a more natural day cycle.

Product Safety Lamps can be fragile pieces of equipment. Please follow the following steps to ensure the safe fitting and use of fluorescent lamps. At either end of a fluorescent lamp you will see two brass coloured connection pins. These are the electrodes that take energy from the controller to start and run the lamp. These are quite fragile by nature. It is imperative that both pins are safely located into the pin sockets inside the lamp holder before the lamp is pressed into place. Failure to line the pins up correctly will cause the pins to bend and snap and break through the lamp cap rendering the lamp unusable. The Ultra-seal lamp ring must be unscrewed from the lamp holder and placed over the lamp prior to fitting and only re-seated onto the lamp holder when you are sure that the lamp pins are seated correctly. High Output T5 lamp leads must be fully unwound also or you may notice lamp flickering or beaks in illumination. You can also use a very small amount of a substance like Vaseline to lubricate the lamp ring and so stop it fusing to the lamp after long periods of heat. After cooling lamps can be wiped clean with a damp cloth once every two weeks or so to remove any dust build up from the lamp, this in turn will help to maintain the lamps full output. The all important reflector should also be wiped clean at the same time.